Owner, Custom Made Jul 13, 2016

I replaced a Dunkirk XEB-3 (20 yrs. old) with the Dunkirk boiler above. The new one is all most identical to the old one, that is the pipes were located same as the old, so gas and water lines were easily plumbed. The old electrical wires could be used although lengthened to connect to the digital controls. The circulators location has changed, it's still provided with its wiring provided. Venting is the same as the old one. I was happy to get another Dunkirk that installed easily.

Great Furnace Jul 12, 2016

It was an easy installation and it went in with no problems. Didn't have to do any adjustments all the factory setting were good and it went right in and hook up was seamless. I would buy another!

Happy - This Purchase Dec 15, 2016

the system works great in my small beach house - less than 2000 SQ ft. also removes a good bit of moisture leaving the air very comfortable - I would purchase again.

Thank You For Friendly Service Aug 20, 2016

Thank you, good product!

Warmwire Heated Floor May 28, 2016

I installed a WarmWire heated floor in a 6'x8' coat room that had no other source of heat. It is on a concrete slab with 2 outside walls and a wall to an unheated attached garage. I glued 2 6mm thick sheets of Cerazorb synthetic cork directly on the concrete. It was super easy to lay the wire on top on the cork using the metal clip system provided. To be safe, I laid a sheet of 1/4" luan plywood on top of the wires while laying the tile. I checked the resistance in the wires at each step... more